When a work van sits on the shoulder with a flat, you lose the repair cost plus the jobs you missed. For small businesses with a handful of vehicles, tires are one of the easiest areas to manage with a simple routine. Here is a checklist you can adapt to your own fleet.
Daily: a quick walk-around
Fleet maintenance guides recommend a visual check before each shift. It takes a minute per vehicle and should be part of the driver's routine. Look for:
- Cuts, cracks, bulges or bubbles in the sidewall.
- Nails, screws or other objects embedded in the tread.
- Uneven or unusual wear.
- Missing valve caps or damaged valve stems.
- A tire that looks lower than the others.
Train drivers to report anything unusual right away, and make it easy for them to do so. Driver feedback is one of the best early warning systems you have.
Weekly or monthly: gauge checks
Use a quality gauge and check pressure on every tire, including the spare, when tires are cold. Use the vehicle manufacturer's recommended pressure from the door placard or owner's manual, not the maximum on the tire sidewall. A TPMS warning light is not a substitute for gauge checks, since it typically triggers only after pressure has dropped a good deal. Many guides suggest weekly checks for work vehicles and, at a minimum, monthly. In South Florida's summer heat, pressure readings swing through the day, so keep your checking routine consistent, ideally before the vehicles head out.
Measure tread depth
Check tread with a gauge, not just by eye. Federal rules for commercial motor vehicles set minimums of 4/32 of an inch on steering-axle tires and 2/32 of an inch on other tires, measured in a major tread groove. Those rules apply to certain heavier commercial vehicles, so confirm which ones cover your fleet. For light-duty vans and pickups, 2/32 of an inch is the general replacement point, and hard-working fleets may choose to replace earlier. Many fleets set their own company standard that is a bit higher.
Rotate, balance and align on schedule
A common rule of thumb for rotation is every 5,000 to 8,000 miles, adjusted for the vehicle and its duty. Check each vehicle's owner's manual. Uneven wear can point to alignment, inflation, suspension or loading problems, so treat it as a clue, not just a reason to buy tires. Heavy loads, curbs and potholes can knock alignment out, and South Florida roads have plenty of both.
Watch for repeat air loss
A tire that keeps needing air has a problem. It could be a puncture, a bad valve, a leak where the tire meets the wheel, or a damaged wheel. Topping it off over and over only hides the problem. Take that vehicle out of service until it is diagnosed.
Respect the load rating
Stay within the vehicle's and tires' load ratings, spread weight evenly, and do not overload for just one more job. Vehicle weight and payload affect how quickly tires wear, and overloading can add heat and stress. If your vehicles carry heavy equipment, ask a tire professional about the right tire type and load range for your use.
Keep simple records
Write down what you find. Even a basic spreadsheet with the vehicle, date, pressures, tread depths, rotation date and any repairs helps you spot patterns, such as one van that always wears its front tires faster. Records also help with warranty claims, which often require proof of maintenance.
Fleet tire checklist
- Daily: visual walk-around for damage, wear and low tires.
- Weekly or monthly: gauge check on all tires including the spare.
- Monthly: tread depth measurement and valve and wheel inspection.
- Every 5,000 to 8,000 miles (check your manual): rotation, plus a balance and alignment check as needed.
- Always: log findings, take vehicles with unexplained air loss out of service, and stay within load ratings.
Plan ahead for downtime
Schedule routine tire work for slower days instead of waiting for a failure, and keep an eye on seasonal patterns, such as more flats after storms or construction. Know which vehicle needs attention next, and keep a spare plan for key vehicles.
Need a hand?
Running a few vehicles? We handle fleet and commercial work at the shop, and our mobile service can come to your lot so your vehicles spend less time off the road. Stop by our shop at 7712 West Oakland Park Blvd in Sunrise, or let our mobile service come to you across Broward, Miami-Dade and Palm Beach. Call (954) 773-1896 or book online.
Frequently asked questions
How often should fleet vehicles have tire pressure checked?
Many fleet guides suggest weekly checks, and at least monthly, using a gauge when the tires are cold. Pressure should match the manufacturer's recommendation on the door placard or in the owner's manual.
What is the minimum tread depth for commercial vehicles?
Federal rules for commercial motor vehicles list 4/32 of an inch for steering-axle tires and 2/32 of an inch for other tires. Check which rules apply to your vehicles, and note that light-duty fleets commonly replace at 2/32.
Can mobile service handle fleet tire work?
Mobile service can handle common tire work at your location, such as installs, balancing and flat repair. Call (954) 773-1896 to talk through your fleet's needs.