A flat on the highway shoulder or in a hot parking lot is stressful. The steps for changing a tire are simple, but the order matters, and your safety comes before everything else. If the spot is unsafe or you are not comfortable, calling for help is a perfectly good choice.
Before you touch a tool
- Get out of traffic. Turn on your hazard lights, slow down gently, and look for a parking lot, side street or exit ramp. If none is available, use level, well-lit ground on the shoulder.
- Secure the car. Put it in park (or in gear for a manual), turn it off, and set the parking brake. Wedge a tire on the opposite corner if you have wheel chocks.
- Keep people clear. Passengers should wait well away from moving traffic.
- Read the manual. It shows where the spare, jack and wrench are, and where the jack points are on your vehicle.
The steps
- Loosen the lug nuts first. With the wheel still on the ground, turn each nut a quarter to half turn counterclockwise. The car's weight keeps the wheel from spinning. Do not remove them yet.
- Place the jack at the right spot. Use the jack point listed in your owner's manual, on solid metal and not plastic trim. On soft ground, put a board under the jack.
- Raise the car until the flat is just off the ground, with room to fit the inflated spare.
- Never get under the car while it is on a jack.
- Remove the nuts and the flat, and keep the nuts somewhere safe where they cannot roll away.
- Mount the spare, lining up the holes with the studs, and hand-tighten the nuts in a star pattern.
- Lower the car until the tire touches the ground, then tighten the nuts firmly in a star pattern. Lower it fully and remove the jack.
- Stow everything. Put the flat, jack and tools back in the car.
After the change
Check the spare's pressure as soon as you can. A temporary spare usually needs a higher pressure than your regular tires, and the right number is on the spare's sidewall or in your manual. Drive within the limits printed on the spare or listed in your manual. AAA notes that temporary spares are typically limited to about 50 mph. Check your owner's manual for the lug nut torque specification, and consider asking a shop to check the nuts with a torque wrench soon after. Then get the flat inspected, repaired or replaced.
Checklist for the glovebox and trunk
- Owner's manual
- Working jack and lug wrench
- Spare tire with correct pressure
- Wheel chock or wedge, flashlight, gloves
- Locking wheel nut key if your wheels have them
When to call instead
Do not change the tire if you are on a narrow shoulder with fast traffic, on soft or sloped ground, or if the lug nuts will not budge. In those cases stay safe, keep your hazards on, and call for help. With sand, summer storms and heavy traffic around South Florida highways, a spot that looks fine can turn dangerous quickly. Check the spare each month too. Many drivers find out in the middle of a flat that it is low on air.
Practice makes it easier
The worst time to learn is when you are on the shoulder with traffic going by. Spend ten minutes in your driveway one weekend and find the jack points, the lug wrench and the spare. Learn how your spare is released, since some are lowered from underneath the car, and read how to use any locking wheel nut key. If you have never loosened your lug nuts, try it once. Some are tight, and you want to know that before you are in a hurry.
Common mistakes
- Jacking before loosening the nuts, which makes the wheel spin and the job harder.
- Using the wrong jack point. This can damage the car or let it slip.
- Working on a slope or soft ground. The car can roll or the jack can sink.
- Tightening nuts in a circle, not a star pattern.
- Forgetting to check the spare's pressure until you need it.
- Driving too fast on a temporary spare.
Hot weather and storms
In South Florida, a roadside change can mean sun on hot pavement, or a sudden downpour. Keep water in the car, wear gloves if you have them, and take your time. If lightning is close, or traffic is fast and close, it is safer to stay in a protected spot and call for help instead of working beside the road.
Need a hand?
If you would rather not do this on the roadside, give us a call. We can help at our shop in Sunrise, or come to you with mobile tire service across Broward, Miami-Dade and Palm Beach. Call (954) 773-1896 or book online.
Frequently asked questions
Should I loosen the lug nuts before or after jacking up the car?
Before. Loosen them a quarter to half turn while the tire is still on the ground, so the wheel does not spin. Then raise the car and finish removing them.
How fast can I drive on a spare?
A temporary spare is usually limited to about 50 mph and a limited distance. Check the spare sidewall and your owner manual for the exact limits, and replace it with a regular tire soon.
Do I need to re-tighten the lug nuts after changing a tire?
It is a good idea to have them checked soon after with a torque wrench, using the specification in your owner manual. Ask a shop to verify them rather than guessing.